It allows control of your mount via your PC using a USB cable instead the SynScan hand controller. This Serial/RS232 cable is used to update the Synscan Hand Controller firmware. . The salt lake is only a few inches deep so can readily stand in it. The OTC Satellite Earth Station Carnarvon was established in Australia to meet the needs for more reliable higher quality communications for the Apollo space program. I think you can just use a regular computer CAT5 cable. The cable plugs directly into the RJ11 telephone style port at the base of the controller and into a spare serial port on the computer. 6 pin connector. (write review), http://www.skywatcher.com/download/software/, Programmable Temperature Controlled Switch. This opens up your Sky-Watcher mount to a wide collection of both Open Source and commercial telescope control, planetarium and guiding software. Once connected via the SynScan USB adaptor, most of the these programs will allow you to move your telescope to an item of interest or even click on a star map to position your telescope. Its job is to run the stepper motors for the RA (Right Ascension) drive axis and the DEC (Declination) drive axis. It supports both equatorial or “EQ” mounts Sky-Watcher mounts and Alt-Az Sky-Watcher EQ mounts such as the range of Sky-Watcher GOTO Dobsonian telescopes. In The Box: SynScan USB Adaptor. Have an Orion Atlas EQ-G mount and this cable would not allow a firmware update of the hand controller to work. Michael Goh is a full-time photographer located in Western Australia primarily capturing astrophotography, commercial, portrait, time-lapse, photospheres, event, video and aerial work. Just make sure that the wires are "straight through"...that is, no crossover of any of the wires. Bilya Rock in Morawa in Western Australia. I would suggest looking for one that utilises the FTDI chipset, as these will have drivers that work with Windows 10. The zodiacal light (sunlight reflecting off cosmic dust in the inner solar system) creates a triangle of light up to the Milky Way core. Synscan hand controller extension cable - posted in Beginning and Intermediate Imaging: Has anyone recently purchased an extension cable for their synscan hand controller so you may use the controller further from the mount? Please not you do not require this adaptor if your Sky-Watcher mount already has a USB port or you have a new, Version 5 SynScan hand controller. Units in Stock: 10. 1.1 1.1 Outline and Interface 1.2 Connecting to a Telescope Mount Fig. 8 pin connector. Instructions and the latest firmware for you hand controller can be found on the Skywatcher website here..... http://www.skywatcher.com/download/software/Features: N.B. To connect the SynScan V5 hand controller to your mount, plug the 8-pin RJ-45 connector of the coil cable that came with your SynScan into the corresponding port on the bottom of the hand controller (Figure 1b), and plug the This Serial/RS232 cable is used to update the Synscan Hand Controller firmware. Image 2 - "The Light Within"Nambung National Park in Western Australia. Canon 6d Tamron 15-30 x 63 image panorama at 30mm F3.2 ISO 5000-6400 25-30s (last few photos were at shorter shutter and higher ISO) tracking mount ... Our ambassador Astrophotobear describes this fantastic image below. The table below lists the … About this image:"Another World" – Salt lakes during the summer heat sometimes dry up so much that they create interesting textures as the salt rises to the surface, dries and creates pressure ridges before they rupture and crack. Those who have clear skies be sure to check it out. Edited by RandallK, 21 October 2018 - 09:24 PM. Product Code: SYN01.